TOPIC:

Had such a blast, I was watching my top farce. (A manta ray someone stuck a top force body on top) I was scavenging it for parts but I found that it had universal joints on back axle, coupled with bearings, a hard mid shaft.... It dawned on me, it was a 100% genuine Top Force that someone had to replace the GRP chassis because dry and or expensive markets.

I didn't had the nerve to junk it reassembled previously removed parts, put a 2.4 RX plus tamiya ESC and gone to a sand parking.... Bloody heck! Sure the Johnson 540 can move, hasn't had this amount of fun in ages! Really the top force DNA can be felt even if hampered through a plastic bathtub chassis.

Nice! Are you sure that it is not a terra conqueror? The TA01 is the best!!!

Sounds a bit like the car that's my avatar (reversed).

Today tried to use it again (The Top Force) got the A5 part (fwd gear housing) to snap on A4 piece screw mounts, so the car had to badly return to me dragging the chassis on the dirt (the screw mounts held the H were dampers are bolted) luckily when I buy a mix-master car I do so it comes with a lot of spares, so had a tree of A parts, so spend this afternoon replacing them.

fitted a Absima thrust eco 18t motor to my hornet so took it out today
and it flys with the gps on it clocked 23mph got to be careful when turning
at speed as it rolls

puted with my step daughter 's boyfriend 3cubic meters of bull bip in the trash. And it's not ended.

Forgot about these, collected them a couple of weeks ago.

Also replaced a servo in my rere Willy wheeler, it now stops cornering same time as I tell it to.

Last night I bent an axle!



Now I have four new axles incoming.

SRB axle?