TOPIC:

Rebuilding the Pro -X ready for next years enduro Rebuilt gearbox and polished the drive shafts, corrected case bolts, Stripped and cleaned all arms and polished pins. Tidied all wiring, Replaced all shock mount hardware with stainless. Polished alloy caps on shocks and rebuilt shocks, replaced front bearings. Waiting on replacement tie rods and ends, Have trimmed the body ready for paint

 

well the local hobby club "sacked" the tiny Stig, have to reprint him. Meanwhile the presenter for the street versions is ready.

 
 
 

They sacked The Stig......  That's against the laws of physics.

On a side note, I miss Stig.  Been binging on The Grand Tour, and "The American" is just outright boring and annoying.

Today, I had time to work on my lem design blw body. Repaired the main body glue and soldering . Now it's a one piece body and glued the cockpit.
now need to fill it and put the wide body kit.
 

Very cool.
Though i see a problem. I forgot to tell you i didnt print the part from z=0. I thought you would only exchange the broken a pillar part, so i started the print at the rear strut of the triangle window,
You are missing 29mm length behind the top end edge of the rear strut of the window. Oh badword, i didnt thought about that and didnt communicate it either. I am deeply sorry.

 


 

Aahh ok it's why the cockpit is too long now?

yes

Finally got the push bar back from my paint guy. Installed with new lights and the decals courtesy of Nathanael at Mciracing.ca!!

Why these ladies love wearing scarfs with pride

Did more driving my 6x6 BullHead truck today as son of my landlord wanted to co drive with his little rc.