TOPIC:

I normally put my cars on little blocks to keep tyres from flat spotting but after today that had to change. I went to get one out the the cupboard and the block of wood fell out, right on my foot. Lucky I was wearing my steel cap thongs so it was just a minor flesh wound. I needed a better idea, so after countless hours of planning, days of stress over how to rectify this, I came up with this idea. Fits all WW's, swb and lwb WW2's.

You could use foam block too. (like I made when I had enough place on my shelves)
Good idea the suspension

I also intend adjusting the shelves so I can hang the willy's front top and put mini's, avante etc on blocks underneath. The foams a good idea, my mates plastics factory has loads of it that they chuck out.

Can't fault your ingenuity there ... is a Willy naturally balanced at that point, or are they being held off the back wall by the wheelie bars?

They are naturally balanced Jonny just a small front lowering

I'm not sure where my willy's balance point is but in regards to the cars, they are almost balaced at the roll bar point. Actually as a fine point, if you look at top car, it's a SWB and almost level, the second one down is a LWB, you'll notice its tilted more forward. The blue one's not a true willy, it's a GF-01, it's almost nose diving.

All done and moved in. got hard white foam from work

I've installed an anti theft device.