TOPIC:
Ford XLT Roll Bar 12 years 2 months ago #30709
|
As part of the "Ingleburn box" I got a XLT Roll Bar, unfortunately the P/O butchered the bottom of it
 Soooo as part of an ongoing project I decided to manufacturer one  After the first 2 attempts 3rd time lucky  The 1st version was more to see where to start the bends and was made out of 4mm stock, the 2nd version was made out of the required 6.3mm stock and allowed me to play with the shape, so the 3rd and final version is just right  
If you can't fix it with a hammer, you've got an electrical problem mate
 |
|
|
Please Log in to join the conversation. |
Ford XLT Roll Bar 12 years 2 months ago #30710
|
Top bending
|
|
Please Log in to join the conversation. |
Ford XLT Roll Bar 12 years 2 months ago #30730
no tool  I don't think they make 1 to do bends this small  Using a former helps ( round bar with the correct radius ) but so far I have patience my best friend If you can't fix it with a hammer, you've got an electrical problem mate
|
|
|
Please Log in to join the conversation. |
Time to create page: 0.198 seconds
